Product Description
1958-1964 Chevy Impala Complete Lowering Air Ride Suspension System Kit
Order this complete air ride suspension system designed by True Suspension specifically for the 1958-1964 Chevrolet Impala sedan, a full front-to-back setup that lets you drop your classic on the ground at a show and drive comfortably on the highway, all with one integrated system rather than a patchwork of separate parts.
Up front, a set of front air spring mounts (upper mounts bolt-on, lower mounts weld-on or optional bolt-on, hardware not included) pairs with a front shock relocation kit that includes upper mounts, lower mounting bolts, and a pair of gas-charged shocks because dropping the front end this far means your shocks need to be relocated to keep working correctly, not just left in their factory position. Out back, rear air spring mounts bolt on up top and weld on at the bottom. The air spring setup itself uses a mix of 2500 D2 series and D1 series air springs, front and rear respectively, matched to the geometry of this specific chassis.
Powering it all is a 1/3 HP compressor rated for 100% duty cycle, backed by a 40 amp relay and a 3-gallon, 5-port stainless steel air tank rated to 1000 PSI max. Control comes through an Active Air pneumatic paddle switch controller, non-electric, with a 150 PSI lighted gauge (white or black face depending on stock), giving you slow, smooth front-to-back control without complicated electronics. A 90-120 PSI pressure switch keeps constant air pressure maintained automatically. The kit includes a 50 ft roll of 1/4" OD air hose and a complete 1/4 tube fitting pack to connect everything, including a drain plug for the air tank (fittings may vary depending on stock).
This is one of many air ride suspension kits we offer. Given the complexity of a full classic-car air-ride install, we strongly suggest a professional installer install this kit.
Kit Includes – 1958-1964 Impala Complete Air Ride Suspension System
- Front air spring mounts (bolt-on upper, weld-on or optional bolt-on lower)
- Rear air spring mounts (bolt-on upper, weld-on lower)
- Front shock relocation kit with 2 gas-charged shocks
- 2x 2500 D2 series air springs, 2x 2500 D1 series air springs
- 1/3 HP 100% duty cycle compressor with 40 amp relay
- 3-gallon, 5-port stainless steel air tank (1000 PSI max rating)
- Active Air pneumatic paddle switch controller with 150 PSI lighted gauge
- 90-120 PSI pressure switch for constant air maintenance
- 50 ft roll of 1/4" OD air hose with complete fitting pack and tank drain plug
- Designed and made in the USA
- 1 Year Warranty
Why This Complete System Stands Out
- Purpose-built for the 1958-1964 Impala chassis, not a generic air ride kit adapted to fit
- Front shock relocation kit included, so your shocks keep working correctly at full drop
- Full front-to-back control from one integrated pneumatic controller and gauge
- 3-gallon stainless tank and real compressor give genuine reserve air, not just switch-and-wait
- Designed and made in the USA, backed by a 1 Year Warranty
NOTE: We suggest a professional installer with proper equipment to install this kit, given the complexity of the full system.
Please note: Neither the manufacturer nor the seller assumes liability for injury, loss, or damage arising directly or indirectly from installing or using this kit. The user assumes all responsibility for this custom suspension kit and its proper use.
Looking for other classic Impala or custom air ride options? Browse the full Chevrolet Impala Custom Air Ride Kits category, or explore our Custom Air Ride Kits and Air Ride Management Kits selections for other builds.
Get 5% off your first purchase. Use code 'FirstPurchase' at checkout!
